OFA 9910 RDF files

akkhandelwal · Post by **akkhandelwal** » Mon May 11, 2009 6:22 pm

I am new to the forum and need some help.

I just downloaded OFA 9910 using JP1 interface. Where do I find the RDf file for this remote?

While downloading IR8.0 reads this remote as XCPT0CPT , processor as
Samsung S3C8 and interface as JP1.

any advise is welcome.

gfb107 · Post by **gfb107** » Mon May 11, 2009 6:25 pm

The RDF is included in the standard RDF zip file. You want all the RDFs, not just the RDF for your remote.

Sounds like you haven't read JP1 How-To's and Software Tools

akkhandelwal · Post by **akkhandelwal** » Mon May 11, 2009 9:33 pm

I had already downloaded RDF.zip files, unzipped it, set the directory in IR.exe. I am able to select the URC 9910 remote also from the file menu.

However, when I download data frm my URC 9910 remote, I get a warning that there is no rdf file for the remote and after the download is done, I have only two tabs in the program; General and Raw, and in the raw tab, there are data.

I am unable to proceed further from this point. If I can copy the raw data, I can paste it in remote master and do something, but I dont know how.

Thanks for your help

akkhandelwal · Post by **akkhandelwal** » Tue May 12, 2009 5:09 am

Earlier I had all the files for IR.exe in a folder on D drive. Once I moved the folder to c drive I was able to download it in the URC 9910 format.

Thanks for your help.

Post by **The Robman** » Tue May 12, 2009 6:20 am

When you had the files on the D drive, did you reset IR so that it pointed to the D drive for the RDFs?

Capn Trips · Post by **Capn Trips** » Tue May 12, 2009 8:04 am

To my knowledge, there IS NO XCPT0CPT RDF. The standard 8910/9910 rdf signataure is CPT0CPT0, and if you got a remote with the extender loaded, it could be CPT0CPX1 or CPT0CPTX2 or otherlike that. Where did you get XCPT0CPT?