Converting Learned functions to device upgrades—problem

Larry Legg · Post by **Larry Legg** » Sat Mar 01, 2008 12:39 pm

I have an 8910 remote. I have learned about 11 keys with the remote that I want to transfer back to the remote as a device upgrade to save memory. I have upload the file from the remote to JP1 version 7.09. I look into the "Learned Signals" tab to see the data and the info is: Protocol=Denon, device=8, OBC=0, Hex Cmd=00, & EFC=018.

The data is the same for every one of the 11 keys.

However, when you edit one of the learned function the data displayed in the window is different. To create a new device upgrade I will need the correct data to enter in RM's functions window. Is there a work-around for this?

I know the learned data being downloaded from the remote is good as I can upload different data to the remote then upload the saved learned functions back to the remote and the remote works fine with the device.

The device I am trying to create is a Proceed AVP surround sound processor. Not sure if that makes a difference or not. I have repeated the process twice with the exact same results.

Thanks for your help

mdavej · Post by **mdavej** » Sat Mar 01, 2008 1:01 pm

That device uses a custom protocol which you wouldn't have been able to figure out. Use THIS upgrade instead. Just change the remote type in RM to match your's (8910).

Post by **vickyg2003** » Sat Mar 01, 2008 1:10 pm

Larry, Do your learned codes work? If so, then it sounds like this code is very close to the denon and may need to be decoded by hand by an expert. There are very few people that can do that. So if you want them to do you the favor, its best if you post your IR file in the diagnosis area with a LINK here.

Larry Legg · Post by **Larry Legg** » Sat Mar 01, 2008 1:33 pm

vickyg2003: Yes, the learned codes work. I will post in the diagnosis area and link to here.

mdavej: I have tried the PAV upgrade before with no luck. I thought it should operate both the AVP and PAV. I will give it another try.

Post by **vickyg2003** » Sat Mar 01, 2008 1:54 pm

Yes, I took a look at another Proceed AVP file and it too is showing the
text from CCFtoEFC and it too is having difficulty interpreting the signals. Interpretting them as Denon 8:018 ?EFC 018.

This will probably need a special protocol as well as an upgrade, like that Proceed PAV signal did.