985
From JP1 Remotes
(985) CBL Device Multiplexor (Official)
Preset up to four CBL setup codes for later recall.
- TAP the CBL device button - RELEASE
- PRESS and HOLD the SETUP button until the red LED flashes twice, then RELEASE.
- TAP 9 - 8 - 5.
- TAP a button that will later be used to recall the setup code
- ENTER a valid 4-digit CBL setup code (2 blinks)
- Repeat previous 2 steps for up to 4 setup codes
- PRESS and HOLD the SETUP button until the red LED flashes twice, then RELEASE.
Change the CBL setup code to one of the presets configured above.
- TAP the CBL device button - RELEASE
- PRESS and HOLD the SETUP button together with one of the buttons specified in step 4 above until the red LED flashes twice, then RELEASE both buttons.