| View previous topic :: View next topic |
| Author |
Message |
skittles
Joined: 16 Dec 2003
Posts: 5
Location: wisconsin
|
 Posted: Tue Jan 06, 2004 7:34 pm Post subject: upgrade where to now |
 |
|
Have a 8811, made some upgrades in remote master, I am not sure how to get them to the remote, am useing IR401, interface is good , just do not see how to upload my upgrades, read the read me's and I must be missing something , any suggestions? thanks
_________________
If it an't broke , lets see what else it can do. |
|
| Back to top |
|
 |
Mark Pierson
Expert
Joined: 03 Aug 2003
Posts: 3017
Location: Connecticut, USA
|
| Posted: Tue Jan 06, 2004 7:45 pm Post subject: |
|
|
Copy the Upgrade Code from RM's Output tab and paste it into IR's Devices tab (use the Add button). Make sure to assign the device type and setup code to the proper device button on IR's General tab. Connect the JP1 cable and upload to the remote. Disconnect the cable, save the IR file, and test the remote.
_________________
Mark |
|
| Back to top |
|
|
skittles
Joined: 16 Dec 2003
Posts: 5
Location: wisconsin
|
| Posted: Tue Jan 06, 2004 10:53 pm Post subject: Thanks |
|
|
Will do, and post back.
_________________
If it an't broke , lets see what else it can do. |
|
| Back to top |
|
|
skittles
Joined: 16 Dec 2003
Posts: 5
Location: wisconsin
|
| Posted: Tue Jan 06, 2004 11:33 pm Post subject: ok |
|
|
I did as suggested, copyed into IR, and made sure device and setup codes are correct. I am useing Sony advanced codes for my upgrade. But when I paste it into IR. It has device and code on the left, all functions listed , but says unmapped? Sorry if this is a dumb question, did a search, checked read me's. Maybe I am trying to move to fast? Thanks skittles
_________________
If it an't broke , lets see what else it can do. |
|
| Back to top |
|
|
gjarboni
Expert
Joined: 20 Sep 2003
Posts: 294
Location: Columbia, MD
|
| Posted: Tue Jan 06, 2004 11:39 pm Post subject: Re: ok |
|
|
| skittles wrote: | | I am using Sony advanced codes for my upgrade. |
It sounds like you are trying to add on to a device code that is already in memory. RM doesn't work that way. If you just want to add a few functions to a device that already exists in your remote, you should use the keymoves tab in IR. Enter the EFC's, the device code that they are part of and what key (and device) you want to bind them too. |
|
| Back to top |
|
|
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
File Section
Wiki
