Page 1 of 1
Could you use this as an eeprom burner?
Posted: Wed Jul 21, 2004 8:59 pm
by tim2xu
would it be possible to use your cable and software to burn eeproms for other
uses such as upgrading a bios? It was just a thought....
Posted: Thu Jul 22, 2004 12:11 am
by mr_d_p_gumby
The JP1 software would not be of much use for this, but the cable should be able to communicate with most I2C serial EEPROMs, given that you connect it correctly, and there aren't any 5v-vs-3.3 volt issues. I doubt that you'll find very many consumer devices with a BIOS that can be upgraded this way, though.