Page 1 of 1
Code for Sharp Surround Receiver on URC-6131??
Posted: Sun Oct 05, 2003 11:25 pm
by grooves12
There is no code listed for Sharp Audio Receivers in the URC-6131. Is it possible to program functionality of one of these receivers using Advanced Program Codes??
Do I need to get a JP1 capable remote to make it work with this device??
Posted: Mon Oct 06, 2003 9:07 am
by The Robman
Shapr receivers can't be too popular because I checked both the JP1 file section and the Pronto file section and didn't find a single file for them. So, if you're willing to get into JP1, I would recommend getting a JP1 compatible learning remote which you could then use to create an upgrade. (The Sharp infrared protocol is supported here).
Just FYI, the URC-6131 can be made JP1 compatible with a small hardware modification, but it's not a learning remote.