Code for Sharp Surround Receiver on URC-6131??

grooves12 · Post by **grooves12** » Sun Oct 05, 2003 11:25 pm

There is no code listed for Sharp Audio Receivers in the URC-6131. Is it possible to program functionality of one of these receivers using Advanced Program Codes??

Do I need to get a JP1 capable remote to make it work with this device??

Post by **The Robman** » Mon Oct 06, 2003 9:07 am

Shapr receivers can't be too popular because I checked both the JP1 file section and the Pronto file section and didn't find a single file for them. So, if you're willing to get into JP1, I would recommend getting a JP1 compatible learning remote which you could then use to create an upgrade. (The Sharp infrared protocol is supported here).

Just FYI, the URC-6131 can be made JP1 compatible with a small hardware modification, but it's not a learning remote.