Argh! Wrong JP-1 cable!

Nos402 · Post by **Nos402** » Thu Feb 19, 2004 5:49 pm

I ordered a pre-modified URC-6131 remote with a JP-1 cable from bluedo.com, and when it arrived today, both the remote and the cable had male ends. Is there any quick fix besides mailing it back? Is there somewhere locally I might be able to get another cable? Or may just a new end for the one I have? I live in Austin Texas, but I just wasn't sure where to begin looking. Grr! I was so looking forward to getting this all set up tonight!

gfb107 · Post by **gfb107** » Thu Feb 19, 2004 5:57 pm

You should be able to just pull the pin header out of the JP1 cable.

Nils_Ekberg · Post by **Nils_Ekberg** » Thu Feb 19, 2004 5:58 pm

Nos402 wrote:I ordered a pre-modified URC-6131 remote with a JP-1 cable from bluedo.com, and when it arrived today, both the remote and the cable had male ends. Is there any quick fix besides mailing it back? Is there somewhere locally I might be able to get another cable? Or may just a new end for the one I have? I live in Austin Texas, but I just wasn't sure where to begin looking. Grr! I was so looking forward to getting this all set up tonight!

Yes, take the male end out of the cable. It is just a spare just incse you need it.

Nos402 · Post by **Nos402** » Thu Feb 19, 2004 5:59 pm

DOH! Ok, beat me with the moron stick.

Post by **The Robman** » Thu Feb 19, 2004 6:07 pm

Consider yourself beaten!

JP1 Remotes

Argh! Wrong JP-1 cable!

Argh! Wrong JP-1 cable!

Re: Argh! Wrong JP-1 cable!