captureIR Good setting

Buzywoman · Post by **Buzywoman** » Wed Apr 15, 2009 9:47 am

Hello all good morning,y have build a ir probe with qse158 for capture ir

y have the version: prototype 12 build 1 , if the latest build ? not find other new build in the file section.

the default seting wont work,after y have read about read me of digitrace y have set in captureIR max sample size: 32 768 and miracle working

this is my setting working for me,y have lost the default setting and try to find the setting file for setting in captureir folder.
------------------------
Hardware

I/O base adress: 0378

Capture pin: 9

polarity: active hight
------------------
timing

post sampling delay: 1000

auto shut off: 60

max gap time: 400

max sample size: 32 768 ( the same as digitrace setting) work for me
--------------
diagnostic

debug level: 1
-------------------
advanced

thread polarity: 5
-------------------

this is a good setting ?

what's is the good setting for captureir and qse158 ? not find read me for the captureir setting.

Y have a dual core 2.7 and vista 32bits

tanks

buzywoman

Buzywoman · Post by **Buzywoman** » Wed Apr 15, 2009 10:22 am

working yesterday ,digitrace and captureIR received signal and today captureIR not working only digitrace receive signal from remote ?

java problem or setting ? no idea

Buzywoman · Post by **Buzywoman** » Thu Apr 16, 2009 4:53 am

if captureIR not work just open digitrace and captureIR work again.

????

binky123 · Post by **binky123** » Thu Apr 16, 2009 3:05 pm

maybe you have to choose "run as administrator" under vista? it looks like a permissions problem but I'm not that familiar with vista.

Buzywoman · Post by **Buzywoman** » Fri Apr 17, 2009 5:56 am

Hello binky123,good morning ,y have disabled uac in vista.

try test to my laptop with pcmci db25 port,but before try the second test y need mod to grounded 18 to 25 pin in my db25,because jtag 18-25 grounded run and ir not work with my laptop.

Mark Pierson · Post by **Mark Pierson** » Fri Apr 17, 2009 9:03 am

Buzywoman wrote:have disabled uac in vista.

That's not the same as running as an administrator.

Buzywoman · Post by **Buzywoman** » Fri Apr 17, 2009 9:18 am

hello,right click and run as administrator ,is ok.

but my problem,removed printer port pin 1 power is switched qse158 to usb power ,working,reboot and stop working ,removed usb power to return pin1 power and y asume y have burned qse158.

ordering qse158 and retry