I am trying to locate the IR code to program a SlingBox Solo.
We have a Motorola RG2400 I was told by our service provider and the remote is a SRC 200. This model is not on listed on the SlingBox, so I need to manually enter the IR Code it should read. I have not had any luck finding it though.
Anyone have the IR code for this?
IR Code needed
Moderator: Moderators
Re: IR Code needed
Found a match and recorded the IR signals with the JP1 tools to create the following file. I couldn't make RMDU or BIN files from the above ICT file. The IR signals were decoded to SIM2/Async5 which to my knowledge are not currently supported by RM/RMIR. However, I did find the files below. Unfortunately, the ones in red do not load and indicate,"The upgrade you are trying to import is not valid! It does not contain a value for Remote.name." The file which does load is using a custom protocol and doesn't match the OBCs from my ICT files. Instead, I created the files below from the usable file above. However, it is missing the following commands:Cmoen wrote:I am trying to locate the IR code to program a SlingBox Solo. We have a Motorola RG2400 I was told by our service provider and the remote is a SRC 200. This model is not on listed on the SlingBox, so I need to manually enter the IR Code it should read. I have not had any luck finding it though.
Anyone have the IR code for this?
- A
- B
- CallerID
- ChannelPrev
- DayDown
- DayUp
- Favorite
- PageDown
- PageUp
- PPV
- RMDU file: https://www.hifi-remote.com/forums/dload ... e_id=10361
- BIN files: https://www.hifi-remote.com/forums/dload ... e_id=10362
Remotes; JP1.2: Comcast URC-1067, JP1.3: Insignia NS-RC02U-10A, JP1.4 OARI06G, JP2.1: Cox URC-8820-MOTO (still trying to figure out how to make them self-aware.)