JP1 Remotes

mdavej wrote:Can you explain a little further? It works with all macros. If it's not working for you, then you've made a mistake somewhere along the line. HERE's how you should have loaded it.

Gee, you all are going to wonder how I find my rear with both hands. I read this thread several weeks ago, did a search last night and found it again, then went back through and missed the instructions in posts #5 and #10. I think the reason was because I started at the end and worked my way towards the first posts. I found the protocol on page 2 and 3, and didn't go back to page 1. So I wasn't getting the full picture.

Makes sense. Thanks to all (especially Vicky) for being patient with me and my last few boneheaded questions. I'll try it tonight when I'm back at home.

stangbat wrote:

vickyg2003 wrote: The macro speed up protocol is remote specific. Someone would have to write this specifically for the RCRP05B. That would probably be Binky or uncleMiltie.

Correct me if I'm wrong, but from my understanding the protocol given in this thread was written for the RCRP05B. The original poster wanted to speed up his RCRP05B so he could load macros into his Harmony remote.

My bad, I just read page 4 of this thread, before responding.

Your solution was about 30 posts ago.
What about the instructions found here are confusing?

EDIT: I see you already got your answer while I was reading the thread,

I just updated the remote with the fast macro protocol. Works great. Thanks!