JP1 Remotes

drury · Joined: 18 Jan 2004 Posts: 2

I've checked and rechecked every thing to get my 2 week old URC 6131 to communicate.

U2, an 8 pin IC, apparently connected to the JP1 is missing (hard to read the traces). Could this be a recent economy measure and the cause of my problem?

Mark Pierson · Posted: Mon Jan 19, 2004 6:24 am Post subject:

U2 is the EEPROM, which the 6131 doesn't come with from the factory. You'll need to add the EEPROM and JP1 connector before you can communicate with it.
_________________
Mark

The Robman · Posted: Mon Jan 19, 2004 8:52 am Post subject:

Every single URC-6131 that's shipped from the factory has the chip missing, they also have the 6-pin connector missing.

Look for the document that describes how to mod these remotes in the Hardware folder (at Yahoo)
_________________
Rob
www.hifi-remote.com
Please don't PM me with remote questions, post them in the forums so all the experts can help!

drury · Joined: 18 Jan 2004 Posts: 2

Thanks for the help.

It's kind of obvious with hindsite, but I did quite a bit of research yet missed this. Other than "pads" on and excel sheet very little information to say that IC's also need to be added or folk offering it for sale.

Perhaps it should be noted in FAQ or similar incase others are as stupid as me and fail to translate "pads" into "IC MUST be added".

TimH · Posted: Tue Jan 20, 2004 9:31 pm Post subject: