Modix HD-3520

fluffynicesheep · Post by **fluffynicesheep** » Wed Jan 02, 2008 1:35 pm

I currently have a One For All Remote with JP1 cable, and have attempted to upload my details from remote using the IR Software.

Unfortunately each time, I try this the remote control stops working and nothing uploads - I have tried all the battery tricks, pressing buttons etc, but no luck.

Before I start again, I just thought i'd post to see if anyone here has the codes available for the Modix HD-3520 mpeg 4 player.

Many thanks

Capn Trips · Post by **Capn Trips** » Wed Jan 02, 2008 1:43 pm

What remote do you have? Are you sure it's a JP1 and not a JP1.1, or 1.2 or 1.3? The latter use a different cable than the former.

Post by **vickyg2003** » Wed Jan 02, 2008 2:18 pm

First thing that I see is you are saying upload from ther remote when its DOWNLOAD from the remote. If you are uploading when you are supposed to be downloading this could be a big issue.

The next thing you need to do is make sure all your software and DLL's are up to date. There have been intermittant problems with the software on this site. Make sure you have the latest and greatest IR, RDF's and DLL's.

Beyond that we need to know the type of interface and remote you are using. Are they compatible?

Did you make your own interface or buy it prebuilt?

Give us a little more to go on please.

fluffynicesheep · Post by **fluffynicesheep** » Thu Jan 03, 2008 10:12 am

Hi,

I am using a one for all URC 7560 - which I believe is a JP1 compatible remote - as it has the correct interphase on it.

I have purchased a ready-to-go standard JP1 (parallel port) and connected the lead as per the instructions.

I also followed the instructions and hopefully downloaded all the correct programs.

It is then when I open the IR program, select the parallel port and click on the download from remote that it states that nothing is connected, and when I remove the lead from the remote, all my codes and everything have disappeared.

I must be doing something strange, or does this work more effectively with a USB connection?

Many thanks

Dan

Capn Trips · Post by **Capn Trips** » Thu Jan 03, 2008 10:59 am

The parallel JP1 interface should work fine with your remote, which is JP1, not JP1.2, 1.2, nor 1.3. Have you tried reversing the orientation of the 6-pin connector when you plug it in?

Also, what does

fluffynicesheep wrote:when I remove the lead from the remote, all my codes and everything have disappeared.

mean? The codes displayed in IR go blank? Your remote has suddenly lost its programming that you hacd previously done manually?

Try to explain in more detail both your actions and the symptoms, and perhaps someone will be able to recognize an error.

fluffynicesheep · Post by **fluffynicesheep** » Thu Jan 03, 2008 11:55 am

Hi,

Yes I have reversed the orientation of the 6-pin connector when I plugged it in,

Unfortunately codes do not get downloaded to the IR program, as the program does not recognise that my remote is connected.

When I said "when I remove the lead from the remote, all my codes and everything have disappeared". I meant that the remote control itself had lost all codes/macros/programming etc.

Sorry about that.

Capn Trips · Post by **Capn Trips** » Thu Jan 03, 2008 3:04 pm

Whe you attempt an upload or download, what does the remote's LED indicate (and/or the LED icon in the lower left hand corner of IR?)

Have you tried the Interface>Check Interface test? What are the results with different orientations of the connector?