URC 8910 Error Code ( Bad E2 )

Steve · Post by **Steve** » Sun Nov 11, 2007 2:18 pm

I have a URC 8910 remote, and its been working fine...but after a few program loads...I went back in to make a change and now its giving me a memory fault error ( Bad E2 )

I have tried to reset back to factory using the OPS Reset....but thats when it gives me the ( Bad E2 ) error.

Has anyone had this problem, and if so...what does it take to fix it ??

Thanks for any help !!

Steve

Post by **vickyg2003** » Sun Nov 11, 2007 2:35 pm

Is an ops reset a 980? If so, you might want to try a manufacturer's reset 981. That's generally the fixall for JP1 remotes.

Steve · Post by **Steve** » Sun Nov 11, 2007 2:40 pm

I tried the ops reset but still no good...unless there is another way I can reset by using my JP1 cable ??

Steve · Post by **Steve** » Sun Nov 11, 2007 2:43 pm

How do you do a manufacturer's reset 981 ?? ...I do not see it under the setup menu's ??

Capn Trips · Post by **Capn Trips** » Sun Nov 11, 2007 2:52 pm

There's a cleverly-hidden and even more cleverly-named sticky post immediately above your post that describes the MFR reset. This usually fixes the Bad E2 error.

Steve · Post by **Steve** » Sun Nov 11, 2007 10:44 pm

Thanks for the help !!

JP1 Remotes

URC 8910 Error Code ( Bad E2 )

URC 8910 Error Code ( Bad E2 )

Reply

Reply

Reply