8910 with Extender -- LCD Display issues

batrad · Post by **batrad** » Wed Sep 26, 2007 2:17 pm

I have created a new 8910 file using the 8910X3-empty file as the template (this has the extender stuff preloaded), defined the Macros to display custom message when a device is selected, but it still displays the standard messages in the LCD

Appreciate your help in troubleshooting / identifying where I'm going wrong

Thanks

Uploaded file

underquark · Post by **underquark** » Wed Sep 26, 2007 3:03 pm

It's a while since I programmed my 8910 (I use 8820s now) but I think you need to add SET_LCD as the last step in the device-button macro prior to calling the Custom Mode Name.

batrad · Post by **batrad** » Wed Sep 26, 2007 4:14 pm

Tried that.. did a SET LCD as the last step of the macro as well as the 2nd last step (before SHift-AUX) no luck

underquark · Post by **underquark** » Thu Sep 27, 2007 7:13 am

I opened an old copy of one of my 8910 extender IR files, stripped out my stuff and added your stuff:
Link to file.

floyd1977 · Post by **floyd1977** » Thu Sep 27, 2007 5:34 pm

batrad wrote:Tried that.. did a SET LCD as the last step of the macro as well as the 2nd last step (before SHift-AUX) no luck

Actually, SET_LCD displays the setup code, as in an unextended
remote.

What you want to do is define a ModeName special protocol
function on a key. Put this key in your macro instead of
SET_LCD.

Capn Trips · Post by **Capn Trips** » Thu Sep 27, 2007 5:42 pm

Looking at your IR file, it seemingly should work.

Try assigning just the Custom Mode Name function directly to a non-device button with no other commands (like M1 instead of shift-CBL) and see if it works. Then, if it works, incrementally increase the complexity and see when it breaks.