8910 not reading out with RM ?

stacker · Post by **stacker** » Tue Aug 08, 2006 5:19 pm

Hi,

got my 8910 from Rob in the mail today

Quickly built the simple interface, and test with RM seems ok, but download from my remote doesn't seem to end me up with my data

The remote fills the display, but the red led doesn't blink or so.
What might be the problem here?

tnx..

gfb107 · Post by **gfb107** » Tue Aug 08, 2006 5:22 pm

You can't (yet) use RM to upload/download to/from your remote. You use IR for that.

I don't understand what you mean by "The remote fills the display"

stacker · Post by **stacker** » Tue Aug 08, 2006 5:23 pm

Sorry, thats the one I meant

IR, tried with 6.20 and 7.0, both no succes
Display full, i mean all segments on, like reset

Nils_Ekberg · Post by **Nils_Ekberg** » Tue Aug 08, 2006 5:40 pm

1) make sure the connector is in the right way. Just turn it 180 degrees and try again.

2) do a factory reset on the remote

3) turn 1 battery around and try again. Don't leave the battery turned wrong for too long.

4) turn off error checking in IR.

5) make sure the correct port is selected in IR

stacker · Post by **stacker** » Tue Aug 08, 2006 6:05 pm

* turned around the connector: ir comes with message that interface doesn't response.
* turned one battery around, 8910 stops working , dead .

* turn off error checking, where is that in ir?
* factory reset i'll read and findout how

Nils_Ekberg · Post by **Nils_Ekberg** » Tue Aug 08, 2006 8:38 pm

Turning one battery around will stop the remote from working but may download.

Error checking is in the Interface menu

stacker · Post by **stacker** » Wed Aug 09, 2006 3:32 am

No,
none of the suggestions.
But I had to put all rdf's in an rdf dir where i had IR installed. Now it works like a charm

Tnx

Post by **The Robman** » Wed Aug 09, 2006 8:34 am

Not having the RDFs extracts doesn't explain the symptoms that you described, so you must have been doing something else wrong also. But if course, this is acedemic now that you have it working.