Delay in Macro

Marineau · Post by **Marineau** » Wed Apr 19, 2006 4:07 pm

Hi,

Does it's possible to reduce a delay between each function on a macro on 8811 remote control ?

Now, each delay between each command is 1/2 second...
I would like define each delay to 1/10 second.

Note that I don't have an extender.

What is a method for decrease this originate delay ?

Thanks

Post by **The Robman** » Wed Apr 19, 2006 4:14 pm

Without an extender: impossible

With an extender, all macros run alot faster anyway.

Marineau · Post by **Marineau** » Wed Apr 19, 2006 5:24 pm

The Robman wrote:Without an extender: impossible

With an extender, all macros run alot faster anyway.

On 8811, How can install an extender ?
Does an extender is a memory chip ?
Does this chip is standard ?
Does this chip is expensive ?
Does this chip is solder on board ?

Thanks

gfb107 · Post by **gfb107** » Wed Apr 19, 2006 6:56 pm

See What is an extender?