KM upgrade

krisdz · Post by **krisdz** » Mon Feb 13, 2006 1:04 pm

Hi Rob,
It will be possible to add new Outlaw remote to KM?
I’m using the old remote buttons with cross-reference spreadsheet.
It is little bit inconvenient.
I did so on the RDF and posted it in the diagnosis area
I bought used 8910 to learn the projector codes.
Shortly I will have the device upgrade file for the Panasonic PT-AE900 projector
Thanks for your help
Regards
Kris

gfb107 · Post by **gfb107** » Mon Feb 13, 2006 2:01 pm

If you have a good RDF for the new Outlaw remote, you can use RM instead of KM.

krisdz · Post by **krisdz** » Mon Feb 13, 2006 2:54 pm

RM image is also for the old Outlaw. Buttons don’t match.
Regards
Kris

gfb107 · Post by **gfb107** » Mon Feb 13, 2006 2:57 pm

Use the Buttons panel (instead of the Layout panel) until we get an image of the new Outlaw.

Can you provide an image of the new Outlaw?

whompus · Post by **whompus** » Mon Feb 13, 2006 11:05 pm

This is the new one isn't it?

Or is there a newer one?

whompus · Post by **whompus** » Tue Feb 14, 2006 2:48 pm

I put together a rdf, image, and map for this remote.

Its here named outlaw new. I know there is a protocol to follow when doing this but can not seem to find the thread to figure out name to fit.

Someone plz test to help work out any flaws that may be lurking in it.

It loads and excepts upgrades and keymoves and such. Seems to work well. I don't have the remote to test with though.

tj · Post by tj » Wed Feb 15, 2006 5:10 pm

Works pretty good. I got a question though. Why is play and input down with phantom buttons instead of the remote?

whompus · Post by **whompus** » Wed Feb 15, 2006 5:33 pm

I changed input to tone and maped it to remote. Thanks. I am not sure about play. It is like that on old version as well. May be some internal settings with the remote itself.

gfb107 · Post by **gfb107** » Wed Feb 15, 2006 6:53 pm

These problems are caused by slight differences in the names used in the RDF and the associated .map file.

For example, the RDF has PLAY{PScan} while the .map file has PLAY{p.scan}

whompus · Post by **whompus** » Wed Feb 15, 2006 7:45 pm

Cool. Thanks for pointing that out Greg.
I updated it to be play direct as on the remote.
I figured there would be a few flaws in the first couple drafts.

tj · Post by tj » Thu Feb 16, 2006 1:56 pm

Thanks whompus

This match the remote for Outlaw 1070 totally.

whompus · Post by **whompus** » Thu Feb 16, 2006 2:28 pm

Your welcome tj.

The thanks goes to the experts here though. I just revamped (so to speak) there original work.

Just updated the files with a couple more flaws fixed.

tj · Post by tj » Sun Feb 19, 2006 9:50 pm

Thanks again guys

The last update yesterday works great.