Possible to use pid 0112 with remote master?

Mr.Whipple · Post by **Mr.Whipple** » Sat Jan 01, 2005 11:07 am

I put together an upgrade for the Grundig 6150 dvd player using Keymap Master but I haven't had any luck loading it with Remote Master. It uses the pid 01 12 (S3C8+) Custom Protocol for DVD/0775. I only have Excel on my old computer and would like to fine tune the remote on my newer one using RM if possible.

gfb107 · Post by **gfb107** » Sat Jan 01, 2005 11:10 am

PLease provide a link to the KM file you are trying to load and I'll try it out and see what's going on.

Mr.Whipple · Post by **Mr.Whipple** » Sat Jan 01, 2005 2:30 pm

Here is a link to the KM file. Thanks.

gfb107 · Post by **gfb107** » Sun Jan 02, 2005 7:22 am

Try using this: Grundig 6150 dvd player.rmdu

Mr.Whipple · Post by **Mr.Whipple** » Sun Jan 02, 2005 2:08 pm

The file loads great and everything works as it should when I copy into IR. However, if I change anything like move a key and save the .rmdu file, I'm unable to load the new file next time I use RM. I get a file load error...

No protocol found with name "manual", ID=01 12, and variantName=""

gfb107 · Post by **gfb107** » Sun Jan 02, 2005 2:29 pm

Inside the .rmdu file, the protocol name should be Manual. I don't know how it could get saved as manual. When I make a change and re-save it, it gets saved as Manual. What version of RM are you using? The current version is 1.12

Mr.Whipple · Post by **Mr.Whipple** » Sun Jan 02, 2005 9:00 pm

I'm using version 1.12 too. I just tried it again and it does say "Manual" in the error. I guess I didn't capitalize when transcribing the message. The error occurs when I re-save, close RM and then try to reload the file. Strange thing is it works ok if I load yours first then load the resaved file without closing RM in between.

In looking at the two files I noticed the only difference is yours has "Manual Settings" whereas the resaved file contains just "Manual" for protocol name.

gfb107 · Post by **gfb107** » Mon Jan 03, 2005 6:24 am

Try RM v1.13

Mr.Whipple · Post by **Mr.Whipple** » Mon Jan 03, 2005 6:30 pm

Works great. I've added the finished tweaked upgrade to the DVD section. Thanks for your help!