View previous topic :: View next topic |
Author |
Message |
mr_d_p_gumby Expert
Joined: 03 Aug 2003 Posts: 1370 Location: Newbury Park, CA |
Posted: Sat Aug 21, 2004 9:38 am Post subject: |
|
|
Mark Pierson wrote: | You really need to try and program a macro that contains the hard SCAN button (must be done on the remote). This should at least confirm the key code. | Until Felipe confims this, I think it would be safe to assume the keycode is $03. It's listed in the RDF [General] section under FavKey=3, $02B, 15, 4 (first argument is keycode), which would tend to imply that someone researched this at some point. _________________ Mike England |
|
Back to top |
|
|
Mark Pierson Expert
Joined: 03 Aug 2003 Posts: 3017 Location: Connecticut, USA |
Posted: Sat Aug 21, 2004 12:16 pm Post subject: |
|
|
mr_d_p_gumby wrote: | It's listed in the RDF [General] section under FavKey=3, $02B, 15, 4 (first argument is keycode) |
I guess I need to pay a little more attention to detail when looking at an RDF... I missed that one, too.
I'll make the necessary changes to KM for the next release. _________________ Mark |
|
Back to top |
|
|
15-1994
Joined: 23 Sep 2003 Posts: 22 Location: San Diego, California |
Posted: Sat Aug 21, 2004 12:45 pm Post subject: |
|
|
THANKS MARK
Felipe |
|
Back to top |
|
|
Mark Pierson Expert
Joined: 03 Aug 2003 Posts: 3017 Location: Connecticut, USA |
Posted: Sat Aug 21, 2004 2:12 pm Post subject: |
|
|
Ok.. try v8.27. Remember, you need to be using one of the hacked protocols that supports programming the SCAN function directly. Otherwise, KM will not make it available on the Buttons sheet.
Also, if you have any Cable type upgrades, the fav (soft) button has been moved, so they will need to be updated accordingly. _________________ Mark |
|
Back to top |
|
|
15-1994
Joined: 23 Sep 2003 Posts: 22 Location: San Diego, California |
Posted: Sun Aug 22, 2004 2:06 am Post subject: |
|
|
Mark Pierson wrote:
Quote: | Ok.. try v8.27. Remember, you need to be using one of the hacked protocols that supports programming the SCAN function directly. Otherwise, KM will not make it available on the Buttons sheet. |
Mark and Mike,
Now, everything is working perfectly , THANK YOU GUYS
Felipe |
|
Back to top |
|
|
|