Keymoves with 15-1995

Mark Pierson · Post by **Mark Pierson** » Fri May 28, 2004 2:53 pm

tbsmith wrote:Yes, it works fine in Amp mode.

I'd like to know what happens when you properly setup the key move with the 2-byte hex command AND disable the VPT.

I either stumped the expert

Considering I've never even seen a 1995, that's not too difficult!

Mark Pierson · Post by **Mark Pierson** » Fri May 28, 2004 4:03 pm

Mark Pierson wrote:I'd like to know what happens when you properly setup the key move with the 2-byte hex command AND disable the VPT.

Here I go quoting myself again!

While I'd still like to know if the above works, it just occurred to me after re-reading this message and looking at the SA-HE200 upgrade file, that the volume controls use Panasonic:160.0. Setup code AMP_TUNER/0308 in the 1995 uses 1-byte commands that you can try for the key move(s). Set them up as follows:

Bound Device: SAT
Bound Key: Vol+
Device Type: AMP/TUNER
Setup Code: 0308
EFC: 213

Repeat for Vol- = EFC: 217, and Mute = EFC: 151

tbsmith · Post by **tbsmith** » Fri May 28, 2004 10:08 pm

Mark,

I deleted VPT and put in the 2 byte hex command. It didn't work. I then set it up like you suggested with setup code 0308 and.....son of a gun it worked like a champ!

Man, that is cool. It seems so obvious when you know the answer.

I am curious though why you think it didn't work with the 2 byte code.

many thanks for all the help!
Tom