How to convert protocol/OBC info to Pronto Hex?

n8nagel · Post by **n8nagel** » Sun Mar 12, 2023 2:31 pm

I know I've done it but it was a long time ago.

I am trying to convey info that I've figured out to Logitech so they can update their Harmony program for a small Philips TV I have. Their tech support people want the information in Pronto Hex format.

How do I do this? A link to an online how-to guide would be fine, no need to type everything out if the information is out there.

Thanks for any help you can offer!

Barf · Post by **Barf** » Sun Mar 12, 2023 4:13 pm

IrScrutinizer

n8nagel · Post by **n8nagel** » Sun Mar 12, 2023 5:41 pm

Thanks, I've got it installed, but I haven't a clue what I'm doing. So far I've managed to export my working device upgrade to a .girr file and it is now open in IRScrutinizer under "Scrutinize Remote", the "Parametric Remote" tab. I apparently can export this to a .ccf although I need to make some assumptions here.

1. what should I pick? Right now my "Export" tab is set up to Export Format: ProntoClassic, Pronto Model: TS1000, Screen Size 220 240, Button Size 80 30 (I assume the last two don't matter for what I'm trying to do)

2. once generated, how do I read the .ccf file so I can see the Pronto Hex codes for each command?

I apologize is this is super basic, I think I used IRScrutinizer years ago on my very first project years ago (a Luxman TP-117) and never since.

n8nagel · Post by **n8nagel** » Sun Mar 12, 2023 6:14 pm

never mind - I found the hint I needed in another post. I didn't see that "text" was one of the export options, I'm good now I think.

Post by **mathdon** » Wed Apr 26, 2023 5:42 am

n8nagel wrote: So far I've managed to export my working device upgrade to a .girr file

If you used RMIR to do that export, which I presume you did, just open the .girr file with a text editor. The pronto hex for each signal is between the [ccf] and [/ccf] delimiters.