New Remotes

yakpimp · Post by **yakpimp** » Fri Feb 10, 2012 12:14 am

I took some pictures of the inside of the remote today. It looks like the JTAG pads are visible.

Pinout here: http://datasheets.maxim-ic.com/en/ds/MAXQ610.pdf PG27
My Giant Image: http://farm8.staticflickr.com/7165/6850 ... 8d_o_d.jpg
My Slighty Smaller Image: http://farm8.staticflickr.com/7159/6850 ... 22_o_d.jpg

Chip Markings:
MAXQ610
A-UEI
1134B1
+ 475AH

eferz · Post by **eferz** » Fri Feb 10, 2012 12:31 am

yakpimp wrote:I took some pictures of the inside of the remote today. It looks like the JTAG pads are visible.

Yep, looks like they line up just fine.

yakpimp · Post by **yakpimp** » Fri Feb 10, 2012 12:36 am

Look at TCK though, it is going to a different pin.

I edited my post above, because I ended up finding another PDF that did have them lining up.

eferz · Post by **eferz** » Fri Feb 10, 2012 12:44 am

yakpimp wrote:I edited my post above, because I ended up finding another PDF that did have them lining up.

yeah, that one looks better. I wonder how many versions of this chip they've produced. lol

yakpimp · Post by **yakpimp** » Fri Feb 10, 2012 12:51 am

I'll see if I can probe it to see if anything is being spit out over some of these pins.

yakpimp · Post by **yakpimp** » Sat Feb 11, 2012 12:47 am

Turns out the rx and TX pins seem to be putting out some raw data or something. I haven't gathered enough data yet to determine if it is useful.

After looking at the docs some more, I'm going to look into the JTAG interface.

yakpimp · Post by **yakpimp** » Mon Feb 13, 2012 2:00 pm

I decided to setup a wordpress account to keep track of what I'm doing. Instead of continuing to update this unrelated thread.

http://yakhack.wordpress.com