Two 9910 IR/RF Command Centers - How to isolate signals
Posted: Mon Mar 24, 2008 5:05 pm
I'm not very optimistic about this one, but here's my problem.
I've got 2 matched brand TVs which utilize the same Device Codes in separate rooms.
I also have 2 9910 Command Centers (one per room)
When I turn on the TV in one room, it of course turns on the TV in the other room (first time I ran into a negative related to the RF Remotes)
Any ideas beyond preventing the repeated IR signal from reaching the TVs?
I've got 2 matched brand TVs which utilize the same Device Codes in separate rooms.
I also have 2 9910 Command Centers (one per room)
When I turn on the TV in one room, it of course turns on the TV in the other room (first time I ran into a negative related to the RF Remotes)
Any ideas beyond preventing the repeated IR signal from reaching the TVs?