Page 1 of 1
Lutron Grafik Eye 3104 + Jp1
Posted: Sat Jul 14, 2007 4:20 pm
by rmassey
I just installed a Lutron Grafik Eye 3104 in the HT. I am using three of the four zones. I do not have the accessory remote, so I tried to program a RS 2116 with the standard GE codes from here:
https://www.hifi-remote.com/forums/dload ... le_id=2363
I use KM 9.x, set the remote to 2116/17 and I loaded the device code and the protocol into IR.exe. I set the Aux to device 0597 and give it a try.
I get nothing from the 2116 remote pointing it at the GE 3104. Nadda Zip.
What am I missing? Seems like I should be getting some results here.
I also have a RS 1944 and URC 8910 available. I may try it on of those remotes to see if I get some results.
TIA
Re: Lutron Grafik Eye 3104 + Jp1
Posted: Sat Jul 14, 2007 4:33 pm
by Mark Pierson
rmassey wrote:I set the Aux to device 0597 and give it a try.
What Device Type did you assign in IR? The upgrade is HOME:0597 so HOME must be specified on IR's General tab.
Also, check the Notes in the Upgrade to see if any of them apply to your unit:
Standard code set, use device code 255
For GRX A1 - use device code 8
For GRX A2 - use device code 9
For GRX A3 - use device code 10
For GRX A4 - use device code 11
For GRX A5 - use device code 12
For GRX A6 - use device code 13
For GRX A7 - use device code 14
For GRX A8 - use device code 15
Posted: Sat Jul 14, 2007 5:06 pm
by rmassey
Yes, General Tab - Aux/Home/0597 is what I am using.
Also, check the Notes in the Upgrade to see if any of them apply to your unit:
What does that mean exactly? I am using a GE 3104, not any of the GRX A1-8 AFAIK???
Posted: Sun Sep 02, 2007 5:20 pm
by rmassey
Bump - HT remodel is done, GE 3104 and NTGRX 2SL are installed and work fine. I still need to get th 3104 working with a JP1 remote.
Anyone else have any tips to get me running?
Posted: Sun Sep 02, 2007 5:37 pm
by Mark Pierson
You might want to try each of those alternate device numbers to see if any of them work.
Posted: Wed Sep 05, 2007 9:16 am
by rmassey
Well, I actually found an .m5 file on remote central to use with my MX500 remote. I need GE control from this remote anyway, so this solves my problem.
Posted: Wed Sep 05, 2007 6:05 pm
by The Robman
If you get the MX500 to work the Lutron, could you then learn the signals from your MX500 using your 15-2116 and post the results. That way we can create an upgrade that you can use with your 15-2116 and others can share.