Page 1 of 1
Kreatel 1510 stb IR codes for Slingbox
Posted: Fri Jan 05, 2007 3:48 am
by dicator
Hi
I have set up nice Slingbox system with Kreatel 1510 stb, but as the topic says I cannot control that box via internet because I don't have right codes.
I have googled like lunatic and I find couple of posts from this forum also, but no one is solving my problem.
https://www.hifi-remote.com/forums/viewtopic.php?t=6716
This was closest to my case and by my understanding 1760 stb uses same codes as my box.
I would be very grateful if someone could help me with this.
Regards
DiCator
Re: Kreatel 1510 stb IR codes for Slingbox
Posted: Fri Jan 05, 2007 7:09 am
by The Robman
What do you mean by "no one is solving my problem"? The thread that you found contains the answer, specifically if you look at
this post you'll see that there's a link to the Kreatel upgrade file, which the Slingbox user who started the thread has confirmed works. What more do you need?
Posted: Mon Jan 08, 2007 2:28 am
by dicator
I wasn't very clear in what I said..
From the beginning as I have understood these codes,files and upgrade things needs some hardware (wire) to apply those things to the Slingbox. Am I right? So my question is how can I take those codes in action with slingplayer application?
Posted: Mon Jan 08, 2007 7:38 am
by zaphod7501
Posted: Mon Jan 08, 2007 9:19 am
by The Robman
dicator wrote:I wasn't very clear in what I said..
From the beginning as I have understood these codes,files and upgrade things needs some hardware (wire) to apply those things to the Slingbox. Am I right? So my question is how can I take those codes in action with slingplayer application?
You don't need a wire (aka "JP1 Cable") or any hardware to use JP1 upgrades with the Slingbox.
If you go to the top of this forum you'll see a sticky thread entitled
Using JP1 with the Slingbox, as the title of this sticky thread might (hopefully) imply, this is a very good place to start with regards to using JP1 with the Slingbox.
Posted: Tue Jan 09, 2007 1:32 am
by dicator
Ok thanks for your help so far..
I have now imported that Kreatel KM file in RM and I can find from devices Slingbox with PL and JU chips, but I think mine is RV type or some other (IR Blaster version 4)..
So my question is where I can find RDF files to that RV or other?
Thank you for you patience so far
Posted: Tue Jan 09, 2007 6:46 am
by dicator
Hello again...
Now I have get it to work...
I found that needed RDF file from
https://www.hifi-remote.com/forums/dload ... le_id=3285
So now I just need to fix those buttons, because at the moment those are quite a mess..
Thank you very much.