JP1 Remotes

Greets all, I'm in a pickle.. I just started wiring up a Radio Shack 15-2102
remote, I went ahead and cut the traces and such according to the
picture in the Yahoo group. I now notice that the picture only shows
5 wires, as the JP1 interface uses all 6 wires, and after further inspection
it can't be " 1=pin 1, 2=pin 2 etc etc"... so I'm stuck. Can anyone give me
some better info??

Thanks.

I don't remember if the 15-2102 was ever sucessfully JP1'd.

There's a bunch of photos, but no instructions that I could find. I think perhaps the ones from the 15-2103 can be used as a reference.

Thanks, I found it by accident.. Yeah, it's done by same "Stereo Jack"
method as the 1993/2103.