JP1 Remotes

I wanted to use the special protocol : Device Toggler for my dreambox remote, but this protocol have no version for my remote....
Is it difficult to adapt it ?
How can i do ?
I've started to have a look on and hhen i see the various version (for various remote), it looks like only one number is changing :
Rem400:
Upgrade protocol 0 = 01 FD (S3C80)
00 00 02 08 5D 02 00 06 C0 4E B5 C0 03 F5 03 C0
0E B5 C0 04 F5 04 C0 AF
End

URC-5650, URC-6200, URC-6800, URC-7200, UCR-7800:
Upgrade protocol 0 = 01 FD (S3C80)
00 00 02 08 5E 02 00 06 C0 4E B5 C0 03 F5 03 C0
0E B5 C0 04 F5 04 C0 AF
End

....

How to know what would be the correct value for my remote ?
What is the meaning of this value ?

Thanks

benoit

Value for your remote is 59.
It is register in which current device index is stored.

I uploaded new version of special protocols spreadsheet with support for
dreambox and dreambox v2 remotes.
http://groups.yahoo.com/group/jp1/files ... a-beta.zip

great !!!!!

thx ...
[just edited]

It is a good news, but i have pb to make it work ....
If you have little time to explain i'm quite curious to know how you find this value 59 .....

Besides, i installed it in my dreambox v2 remote and here what is my pb :
In device i have :
my sat 1237
my tv under SAT 634

Then i added the protocol, the device 1102, the key move in device SAT, i make shift-1 i would like it use my tv device (634)
so with XL spreadshit i enter
Device 1 : SAT
Device 1 code : 1237
Device 2 : SAT
Device 2 code : 634

result 06 AF
wheras XOR of Sat 1237 (0C B7) and Sat 0634 (02 5C) should be 0e eb

but never mind, it doesn't change a lot of things...
now when i make shift-1, SAT 1237 becomes a SAT 0031 (1 + 30 of shift)

now if i try on the second device (not dream but TV) to switch between a SAT 522 ( 01ec) and SAT 634 (025c) with the hex calculated with the spreadshit ( 00 70) i finally get a TV 586 instead of a SAT 634 ....

I think i should done something wrong......

ok....it work great... !
just made a mistake in the spreashit because as the dream v2 has an offset code, i have to enter the wished device - 30 in Code 1 and code 2 to make it work....

thanks ....