JP1 Remotes

I'm using a URC-9910 remote and would like to implement the extender for this remote. I currently am using only one learned signal, and would like to create an upgrade for it in order to use it with the extender.

I have had to learn the command to control an in-wall IR light switch. The switch is manufactured by Automation Systems (http://www.automation.com.hk) . The command works in the following manner. A quick press and release of the button will toggle the light on and off. Pressing and holding the button will cause the light to dim down/up.

The IR.exe decodes the the quick press and release as:

+1266 -424 +422 -1268 +422 -1268 +1266 -424 +422 -1268 +422 -1268 +422 -1268 +422 -1268 +422 -1268 +1266 -424 +422 -1268 +422 -35084 +1266 -424 +422 -1268 +422 -1268 +1266 -424 +422 -1268 +422 -1268 +422 -1268 +422 -1268 +422 -1268 +1266 -424 +422 -1268 +422 -130648

This data is in the top decode pane ("Sent once when key is pressed")

A button hold is decoded as:

+1254 -418 +418 -1272 +418 -1272 +1254 -418 +418 -1272 +418 -1272 +418 -1272 +418 -1272 +418 -1272 +1254 -418 +418 -1272 +418 -35342 +1254 -418 +418 -1272 +418 -1272 +1254 -418 +418 -1272 +418 -1272 +418 -1272 +418 -1272 +418 -1272 +1254 -418 +418 -1272 +418 -89624

This data is in the middle decode pane ("Sent repeatedly while key is being held").

The reported frequency is 37914.

Thanks in advance for any help/suggestions!

-Dave

I'm pretty sure that is the F12 protocol and it can do either behavior with a control bit.

Make sure you have downloaded the latest version of IR AND DecodeIR.dll copied to the windows\system folder and it should decode.

If you have a problem just post it to the diagnosis section and I 'll take a look when you let me know it is there.

Jon,

That was it. Thanks alot!

-Dave