Page 1 of 1
URC 9910 RF Repair
Posted: Sat Mar 28, 2009 2:26 pm
by rwkyle
I have a 9910 that the RF has stopped working. I believe it happened when my daughter dropped it so I am pretty sure it is not the RF base unit. Has anybody had any success repairing the RF part of the remote and of course if you have how?
Since these are not available anymore any help would be greatly appreciated.
Posted: Sat Mar 28, 2009 6:08 pm
by The Robman
Best I can suggest is that you take the remote apart and look for anything that's obviously not right. The RF puck is near the top of the remote and is quite obvious.
Posted: Mon May 11, 2009 5:38 pm
by akkhandelwal
I had a similar situation and was able to open and repair it. If you drop it, RF is the first thing to stop working since it a seperate module attached to the main board with 4 pin connector and joint at the pins are very weak.
Look at
https://www.hifi-remote.com/forums/viewtopic.php?t=10962