JP1 Remotes

binky123 wrote:cursedgriffin,
Are you able to measure the voltage at the remote pin 6? Another user is reporting similar issues and measured +2.6v at this pin. My guess is that this is marginal and is causing switching problems for the Q4 transistor.

PROGRAMMING MACRO KEYS
Macro keys allow you to set up key
macros to activate certain keys in a specific order. For
example, you can set up a key macro to change the
channels on your TV, raise or lower the volume, and
start recording on your VCR, all with the touch of one
key. If you want to change the macros stored in a
previously-programmed macro key, you’ll need to clear
the key first (see “Clearing a Macro Key” below).

Programming a Macro Key
1. On the remote control, press and hold SETUP
until it blinks twice.
2. Enter 9 9 5. The SETUP key blinks twice.
3. Select a macro key (for example, F1) and
press it once.
4. Press the key sequence you want to program
into the macro. For example, to turn on your
TV and raise its volume, press TV followed by
VOL+.
NOTE: You can program up to 15 key presses into one
macro.
5. Press and hold SETUP until it blinks twice.
6. To add another macro, repeat steps 1 through
5, substituting the new key sequence to be
added in step 4.
NOTE: Programming more than five macros on the
same macro key overwrites previous settings.

Clearing a Macro Key
1. On the remote control, press and hold SETUP
until it blinks twice.
2. Enter 9 9 5. The SETUP key blinks twice.
3. Press the macro key you want to clear once.
4. Press and hold SETUP until it blinks twice.
This macro key is now clear and ready for
reprogramming. If desired, repeat these to clear another Macro.

USING THE MASTER POWER KEY

NOTE: MASTER POWER (PWR) only works in the CBL
mode. If it is not programmed, only the cable
converter will turn on or off. In any other
mode, pressing MASTER POWER (PWR) once
will turn the selected device on or off.
Programming the Master Power Key
1. On the remote control, press and hold SETUP
until the last-selected device key blinks twice.
2. Enter 9 9 5. The last-selected device key
blinks twice.
3. Press PWR once.
4. For the first device you want in the power on
sequence, press a device key (e.g., CBL) once.
Then press PWR once. For the second device
in the power sequence, press its key once (e.g,
TV). Then press PWR.
5. Repeat step 4 up to four more times to add the
second, third, fourth, and fifth device, as
desired.
6. To save the settings and exit the program:
a. Press CBL once.
b. Press and hold SETUP until the CBL key blinks
twice.