Page 4 of 4
Posted: Wed Sep 15, 2010 4:45 am
by vickyg2003
Well it hasn't been tested on the actual device, but the at least now, when we fill in the variables we get from the Thomson, the signal shoots what we expect.
I thought it was just a sling problem, but it was a problem for all the remotes too.
Posted: Sat Sep 18, 2010 5:27 pm
by ron_by
Hey there,
Sorry for taking so long checking back here, I'm real busy with school stuff. And thanks to Rob for drawing my attention. And of course thanks to all of you guys for all the effort, it's really awesome.
Unfortunately it still doesn't seem to be working. I put the new files in place, put the code in, but nothing... no response, none of the buttons seem to work.
Posted: Sun Sep 19, 2010 6:10 am
by alanrichey
Pity. Not sure where we go from here. I assume you did all the checks I suggested ?
Posted: Sun Sep 19, 2010 6:39 am
by vickyg2003
This could be dependent on the Slingbox RDFs. The Thomson uses 004B. Two of the RDF's had 004B built in, and the RDF's had the wrong version (variant 7), but were reporting variant 1. So if this was a PK or an RV slingbox, the data being sent is the wrong information.
So it could be just an RDF issue that would have been corrected by the RDF's that I had loaded up to the development area ealier this week.
Posted: Sun Sep 19, 2010 7:03 am
by alanrichey
OK, I have rebuilt the BIN files using your RDFs.
https://www.hifi-remote.com/forums/dload ... le_id=8927
Let's see if that works.
Posted: Wed Sep 22, 2010 3:51 pm
by ron_by
the new files are not working either i'm sorry to report. i appreciate all the trying though, so thanks very much for that.
Posted: Thu Sep 23, 2010 12:27 am
by alanrichey
Run out of ideas I'm afraid
