JP1 Remotes

I was getting already to upload an IR file for Rob to decode, when I found a tele Systems 7510 RDMU file on my system. It has a custom protocol that seems to match.

The fixed data matched.
I only have the numbers 0-9 and ch+, ch- and power filled in. All of these match with the values that decoded.

So I downloaded the 7510 rdmu file, and most of the values match.

Apps and Teletext are different and each list has a few codes the other doesn't.

I couldn't read the Up, Menu and Exit buttons from your ICTs. I filled in the UP from the 7510 upgrade since all of the other arrows match.

36 might be menu, and 42 might be exit.
Tele Systems TS-7500 RDMU
https://www.hifi-remote.com/forums/dload ... e_id=11535

Fantastic, that is what I call service Hopefully the user will report back, I'll keep you informed.

vickyg2003 wrote:36 might be menu, and 42 might be exit.

Close It was the other way round. Everything else works, so I'll upload it next Saturday with all the rest of this weeks remotes (4 so far)

Thanks again

Al

Hi Alan,
Actually I think 66 might be menu. I had mixed and matched to OBC and Hex columns.

I've updated my file.


Its always nice when the user gives us prompt feedback.

OK, I'll check

If there is a corresponding thread on this somewhere else, could you post a link to it please.

Doh, its only 2 threads down from this one. I had visually searched this forum and the slingbox forum and didn't see it!
https://www.hifi-remote.com/forums/viewtopic.php?t=14303

ok, I think the threads should be merged

User happy