Page 3 of 3
Posted: Sun Mar 06, 2011 4:39 pm
by CryptMan
Hi,
thanks for outlining that again. I did that including press "Bouquet+" and that looks like it works.
I have understood that the first steps will change the way the remote handles internal stuff - okay.
But I still have problems with the last part, adding the multiplexer itself.
What I have to do with "Key moves" and where goes the codes of the remotes I would like to switch between ?
F20Fh is 41 on my remote.
Thanks again for any help.
Sorry for my stupid questions, I'm really new to this stuff. I finished my interface on yesterday ...
Posted: Mon Mar 07, 2011 12:10 am
by vickyg2003
CryptMan wrote:Hi,
F20Fh is 41 on my remote.
That is a good value. If the value was FF this would have scrambled your keys.
Since you are having trouble with the implementatio, put together your IR file and post it in the diagnsis section, and then post a link to that file here. Someone here will take a look and see what might be going on.
Posted: Mon Mar 07, 2011 9:46 am
by binky123
Upgrade Code 0 = 1C 31 (TV/1103) Uses Device Multiplexor Protocol 01FE. BOUQUET+=TV/0680 BOUQUET-=TV/2047
FE 00 21 12 8A 17 E1
End
This upgrade assigns 128A to Bouquet+ and 17E1 to Bouquet- for the TV/1103 device upgrade. The 1 in 128A means TV mode. The 28A hex = 0650. The Dreambox remotes add +30 to setup codes when they are displayed/blinked back so this is really 0680. The 1 in 17E1 = TV. The 7E1 hex = 2017 or 2047.
Now you need to assign Keymoves that will execute the TV/1103 Bouquet+ button or TV/1103 Bouquet- button. These buttons will then execute protocol 01FE and change the setup code to 128A or 17E1 or whatever data is assigned to that device upgrade button.
Posted: Mon Mar 07, 2011 1:26 pm
by CryptMan
Many thanks for your support until now. I think I did what you said ... but I can't get it to work.
Please find my IR file here:
IR File
Last try for me. If you didn't have any other idea I will give up, leave it the way it is and don't bother you anymore
.
Thanks again.
Posted: Mon Mar 07, 2011 3:26 pm
by binky123
I made a mistake(which I've corrected) in the device upgrade I posted above. It should be 1C 31 so that it gets created as TV/1103. In your .IR file and under Devices Tab, change the device mode from SAT to TV.
Posted: Tue Mar 08, 2011 1:37 pm
by CryptMan
FANTASTIC ! It's working now.
But to let all others know, Shift-1 and Shift-2 does not work as key assignments in key-moves.
Many thanks to you.
Posted: Tue Mar 08, 2011 4:09 pm
by vickyg2003
CryptMan wrote:FANTASTIC ! It's working now.
But to let all others know, Shift-1 and Shift-2 does not work as key assignments in key-moves.
Many thanks to you.
Yes that's a known. To shift a number you need to press shift,shift otherwise the remote thinks you are trying to send an EFC.