Page 2 of 2
Posted: Fri Jul 08, 2005 6:48 pm
by The Robman
wiretwister wrote:tried it again......I keep getting out of bounds -1,
I downloaded your file and opened it using IR.exe without any problem. I didn't have to "select" an RDF as IR recognized the remote as being the UniWand. So I'm at a loss as to why you're having problems, and your posts are kind of hard to read so I'm not seeing what I need to in order to try and diagnose your problem further.
Posted: Fri Jul 08, 2005 8:03 pm
by wiretwister
ok......I used RM and converted a ust-4500 upgrade that was wrote for a RS remote to 43000B01 specs, Its a Denon protocol and the device code is 0657 (if I remember right)...after upload is complete, the remote wont give me the setup 2 flash device OK ..........but i can download it from the remote and IR says it is there......Im at a loss, ( but I wont give up ).
One question....I never see the protocol string in the upgrade, is that because it already knows it....or is that a problem???
Sorry about confusing everyone......I have a zillion questions about this stuff...I,ll try again early in the morning.
Wire
Posted: Sat Jul 09, 2005 2:47 pm
by wiretwister
No luck at all..............simply wont control device, uploads to remote, just dont work.
Wire
Posted: Sat Jul 09, 2005 3:37 pm
by The Robman
wiretwister wrote:Anyone up for helping me???????
I think we've already tried.
Posted: Sat Jul 09, 2005 11:24 pm
by wiretwister
OIC.....So Im SOL it seems.
Wire
Posted: Wed Jul 20, 2005 3:44 pm
by wiretwister
UPDATE.....I Figured it out !!
The problem was, the keys were not mapped correct.
Seems the upgrade in the file section does not work with ALL 4500 IRD's.
Re-mapped every key, per a Motorola doc. and everything mapped right except the Power key......
I can finally use the IRD.
Wire