JP1 Remotes

The signals in your file decode to either plain panasonic 165 or panasonic 165 2 cmd signals

There are many utilities here that will decode the signal, and others that will convert the decodes into 5 digit EFCs that you can use against a built in setup code.

I used IRScope for my decodes,
I used ...

I ended up getting a second JP1.3 compatible remote and a cheap FTDI based usb to header jumper cable from ebay.

In addition to using RemoteMaster v2.02a. I found that my RX and TX wires were incorrectly wired leading to the "JP1.2 read failed" message.

I currently have my cable connected as:
pin ...

I'm not sure how you ended up with RMIR 2.02. You should be using 2.02a .


I got caught by the same problem. It turns out that the RemoteMaster webpage has not been updated to point to 2.02a. The link next to "Latest version" on the page http://controlremote.sourceforge.net/ goes to 2.02 rather ...

Please follow the directions shown here to demonstrate that your remote can be successfully put into programing mode, and that the signature can be read.

You're looking to see that 1) toggling RTS will cause the remote to blink twice, and 2) after performing the sequence Set Break, Set RTS, Clear ...

Success in Check Interface only really means that IR was able to recognize the cable. It does not mean that it was able to recognize the remote. Typically the remote doesn't need to be atttached to the cable in order to get a successful CheckInterface. When doing Check Interface, watch the remote ...

I have a Pioneer Elite SC-67 receiver. The original remote that came with the receiver does not have buttons to directly select all of the possible inputs.

I have downloaded a spreadsheet from: http://www.pioneerelectronics.com/PUSA/Support/Home-Entertainment-Custom-Install/IR+Codes for the SC-67 ...

I have an RCA RCRP05BR remote and a USB JP1.2/1.3 cable that is being sold by a seller on ecrater. The cable identifies as a Prolific USB to Serial com port.

On my Windows 7 machine I have installed the prolific drivers and loaded IR.exe. When use the "Check Interface" function the interface checks ...