JP1 Remotes

I assume you're changing these bytes in the Raw Data panel in IR, if so, have you been clicking on the Apply button before you try to load the data into the remote? If you don't click Apply, the changes won't be loaded.

Thanks, I did notice that button, I can see how it could be missed though ...

you could try to force a reset by putting zeros in one of the device setup entries. (you're going to have to figure out where they are, but they're likely the same as the other JP1.3 remotes. The first 8 bytes are the signature, the next two are checksum and the ones after that are the setup for ...

Here's another tip, if you want to make sure that IR isn't changing anything in the memory when you download it (because of a bad RDF) you can go to the Advanced menu and select "Enable Raw Download". This will enable the "Raw Download" button on the General tab which you can use to bypass the RDF ...

Thanks for that suggestion UncleMiltie.

I had tried FF before in hopes that the Processor would reset the eeprom but that had not worked. I just tried the 00 and that also did not work. At this stage it is probably not worth other peoples time. I am learning and this had been a remote that was ...

Unfortunately that did not do it.

The LED will blink twice when I insert the batteries but not after that. I performed the reset as you indicated and the same condition persists. I have Tommy's IR-Widget and no ir single is coming from any of the keys. All keys act like when there is no programming ...

Thanks unclemiltie

Looks like my initial error was that I did not read the remote in RAW format. It had grabbed the Vizio RDF with the same signature. Then uploading that same file back to the remote change some of the bytes, which has deactivated the keys. In this state I can not perform any ...

Looks like this thread has been going for a year - WOW.

Houdini, thanks for not giving up and bumping this thread so that it caught my eye.

Thank you Robman for not giving up and thanks for sharing the Protocol Builder code with your comments included. I cannot believe I have not run across this ...

Thanks for the reply Binky123,

I removed the FixedData section and have been playing around with the Settings section but haven't found the right combination yet. I upload the original ir file to the remote and keys will still not light up the led. That would make since because I probably do not ...

I have:
original OEM remote
RS 15-134 JP1 remote
Tommy's new USB cable

I have the RC-103 Polaroid OEM LCD TV JP1.3 Remote same signature as Vizio TV remote and appearance is very similar but looks like it is different enough not to work properly with the Vizio 30023002 RDF file.

The Polaroid ...

Robman,

Version 7 is functioning like version 5. Short key presses work, long key press only responds to a single code.

Robman,

The macros work on version 6. I will test version 7.

PERFECT! For the JP1 remote direct to the CW3000HD.

Thank you very much Robman. You sure know what you are doing!

GurkhaBeast

The long key presses in the learned ir file do not work. The toggle flip occurs on key release and the learning stopped before the key release so it was not captured.

CH-, VOL-, Record all work on the learned remote

V5 is much better and almost there.

Directly to the Captive Works CW3000HD (apparently not through the sling box according to the previous post)

Single key presses (with a pause or no pause between key presses): works as supposed to. The receiver ...

A little bit better.

Long Key Press followed by a long Key Press, followed by a long Key Press will send a single key code (or respond to a single key code) each long key press. So now it does respond to the same key multiple times.


Short Key presses appears to be identical to V3.

Single Key ...