15-2142, 4-IN-ONE FAMILY FAVORITES REMOTE
Setup Codes For Cable Boxes (Converters):
Setup Codes for DVD Players:
Setup Codes For HTiBs (Home-Theater-in-a-Box):
Setup Codes For Satellite Receivers:
Setup Codes for TVs:
Setup Codes For TV/DVD Player Combos:
Setup Codes For TV/VCR Combos:
Setup Codes For VCRs:
Setup Codes For DBS/PVR Combinations:
Setup Codes For TV/VCR/DVD Combinations:
Setup Codes For PVRs:

Device Types
You can use the remote control's device keys to control these types of devices:
Device Key to UseDevice Type
VCRVCR, TV/VCR Combo
CBL/SATCable Converter or Satellite Receiver
DVDDVD Player
AUX CD players, video accessories, home automation systems

Programming A Device

The RadioShack 4-1 Family Favorites Remote comes pre-programmed to operate an RCA TV, VCR, DVD player, and Satellite receiver. To control devices other than those default brands, follow these steps; otherwise, skip this section.

Before proceeding, find the codes for the devices you want to program in Manufacturer's Codes and write them down or highlight them.
NOTE: To program a TV/DVD, TV/VCR/DVD, or TV/VCR Combo, use the TV key. To program a Personal Video Recorder (PVR), use the VCR key. To program a Home-Theater-in-a-Box (HTiB), use the DVD key. If you have a VCR/DVD combo, you may need to set up both a VCR and DVD code.

  1. Turn on the device (for example, DVD player) and, if needed, load media (for example, a DVD).

  2. On the remote, press a device key (that is, VCR, DVD, CBL/SAT, or TV).

  3. Press and hold P until the red LED blinks twice, then release.

  4. Enter the first four-digit code for your device. The LED blinks once as you enter each digit. If the code is correct, the LED blinks twice.
    NOTE: If the LED does not blink twice, repeat steps 2 to 4 and try entering the code again.

  5. Aim the remote at the device and press Power (or PLAY, if it does not have a Power key). The device should turn off. If it does not, repeat steps 2 to 5, trying each code for your brand until you find one that works. If you cannot find a code that works, see "Searching for Your Code".

  6. Repeat steps 1 to 5 for each device you want to control. For future reference, write down each working device code in a safe place.