VCR Programmer
(150-1996)                 Features                   Faxback Doc. # 63955

Your RadioShack VCR Programmer makes recording your favorite shows and 
movies simple with six easy-to-follow steps marked right on the keys.

Its other features include:

 Extensive Code Library - a resident library contains codes for virtually
                          every VCR and cable converter (or satellite
                          receiver) being made today, as well as several
                          discontinued devices.

   Automatic Sleep Mode - automatically senses inactivity and puts the
                          unit into sleep mode to conserve battery life.

       Daily and Weekly - record one single show, or a weekly series.
            Programming 

To use your VCR Programmer with your VCR and cable converter (or satellite 
receiver), you must perform some simple programming after installing the 
batteries (not supplied).

For best results, please read and perform all instructions in this manual.  
Keep these instructions for future reference.

Your Programmer has the following controls, which will be explained in 
detail at other locations in this manual.

                 UNLOCK - Use to begin the record programming sequence or
                          to cancel a previously programmed event.

                    DAY - Use to set the day of the event you wish to
                          program and to set the clock.

START TIME - HOUR (+/-) - Use to program the start time of the event you
       and MINUTE (+/-)   wish to program and to set the clock.

          RECORD LENGTH - Use to choose the length of the event you wish
                          to program (30, 60, 90, 120 or 180 minutes, or
                          until the tape runs out).

CHANNEL - VCR (+/-) and - Use to choose the channel of the event you wish
              CBL (+/-)   to program.  Also use them for menu navigation
                          during clock setup and ID programming.

                   LOCK - Use to save your programmed event, or to
                          reactivate an event you have disabled.

              CLOCK SET - Use to set the current day and time and to
                          program device IDs.  Use as an Enter key during
                          clock setup and ID programming.

                 CANCEL - Use to exit any programming sequence or test, or
                          to cancel a programmed event.

(EB 1/29/1)