Four-in-One Remote Control
(15-1904)                 Preparation                Faxback Doc. # 47588

Follow these steps to set up your 4-in-1.

1.  Remove the battery compartment cover and install four fresh AAA
    alkaline batteries (RadioShack Cat. No. 23-555).  Observe the polarity
    (+ and -) marked in the compartment.

    Note:  Do not place objects on top of the remote control after you
           install the batteries.  This can press down keys for an
           extended period and reduce battery life.

2.  Refer to "Manufacturers' Codes", in Faxback Doc. # 47585, and write
    down the codes for your original remote controls on the provided label
    that fits on the back of the 4-in-1.  For example, a code for an RCA
    remote control TV is 047.

    Note:  Some remote controls have several possible codes listed.  Try
           each code until you find the correct one.  See "If You Have
           Problems", on Faxback Doc. # 47587.

3.  Press the key for the device you want to set up: TV, CABLE, VCR, or
    AUX.  Press A - B - C, and enter the 3-digit code for the device.  For
    example, to set up the 4-in-1 for an RCA TV with a code of 047, press
    the following keys:

      TV - A - B - C - 0 - 4 - 7

    Note:  The red IR indicator at the top of the 4-in-1 flashes each time
           you press a key.  It also, flashes twice when you enter a code
           that it recognizes.  (This does not mean that it is the right
           code for your device, however.)

4.  Repeat Steps 2 and 3 to setup other devices.

Note:  When the 4-in 1's range decreases or the 4-in-1 operates
       erratically, replace the batteries.

CAUTION:  Be sure to have fresh batteries ready to install before you
          remove the old batteries.  The 4-in-1's memory only lasts about
          1 minute without the batteries.  If the memory is lost, re-enter
          the 3-digit codes for your remote control products.

USING TWO OR MORE SIMILAR DEVICES

Each of the 4-in-1's keys are preset to control particular devices, as
shown in the following list.

   TV Key - TVs Only.

CABLE Key - Cable Converters, Satellite Receivers, and Video Accessories.

  VCR Key - VCRs Video Discs, and Cassette Decks.

  AUX Key - CD Players, Amplifiers, Tuners, Receivers, Home Automation
            Products, Miscellaneous Audio Products.

Normally, you program each key for one of its listed devices.  However, if
you have two or more of the same type of device (two TVs, two VCRs, and so
on) you can convert any unused device key for another type of device.  To
do this, press:

             A - B - C - 9 - 9 - 9 - 
   (unused device key) - (new device key function)

For example, the following key strokes convert an unused CABLE key for use
as a second VCR key.

  A - B - C - 9 - 9 - 9 - CABLE - VCR

To change the CABLE key back to it's normal function, use the following
sequence of key strokes:

  A - B - C - 9 - 9 - 9 - CABLE - CABLE

(BR/eb 7/20/98)