3-IN-1 Easy Remote Control
(15-1916B)                Troubleshooting            Faxback Doc. # 44690

If You Have Problems

Manual Code Search

If the 3 in 1 does not control your remote-controlled devices when you
first set it up, you probably did not enter the correct 3-digit codes for
your devices.

You can try all the codes for the brand of your device, or because many
manufacturers make products using several different brand names, you might
want to search the 3 in 1's entire library by following these steps.

1.  Manually turn on the device you are trying to set up.

2.  Aim the 3 in 1 at the device.

3.  Press the device key, then hold down P until the red indicator blinks
    twice.  Release P.

4.  Press 9 9 1 PWR, then press the device key.  Alternate between pressing
    PWR and the device key until the device responds.

    Each time you press the device key, the 3 in 1 advances to the next
    manufacturer's code in its list.

5.  When the device responds, press and release P to lock in the manufac-
    turer's code.  The red indicator blinks twice.

If necessary, repeat these steps for each device.

Determining The 3-Digit Code

After you set up your 3 in 1 remote control using the manual code search,
you can find which 3-digit code the 3-in-1 is set to by following these
steps.

1.  Press the device key you want to get the manufacturer's code from.

2.  Hold down P until the red indicator blinks twice, then release it.

3.  Press 9 9 0.  The red indicator blinks twice.

4.  Press 1 and count the number of times the red indicator blinks. This is
    the first number of your 3-digit manufacturer's code.  If the red indi-
    cator does not blink, the digit is a zero.

5.  Press 2 and count the number of times the red indicator blinks. This is
    the second number of your 3-digit manufacturer's code. If the red indi-
    cator does not blink, the digit is a zero.

6.  Press 3 and count the number of times the red indicator blinks. This is
    the third number of your 3-digit manufacturer's code. If the red indi-
    cator does not blink, the digit is a zero.

Troubleshooting

If the 3 in 1 stops working after you successfully test the control of each
device, or if you are unable to get the 3 in 1 to work at all, check the
following:

  Be sure you press the device key for the device you want to control.

  Check and replace the batteries, if necessary.

  Confirm that your remote-controlled devices are working properly using
  manual controls or their original remotes.

  If some buttons do not work for your device, you might be able to scan to
  a better device code.

If you are still unable to determine the problem, call our nationwide
Universal Remote Control Hotline at 1-800-955-2599.


(br/EB 10/13/97)