JP1 Remotes

e34m5 · Joined: 14 Oct 2003 Posts: 675 Location: Atlanta

I added a device upgrade (Sony 1758) to the 1067A. It will not work. I tried it both in regular and extended.

This upgrade works fine on my other remotes. Any ideas?
_________________
Paul

unclemiltie · Posted: Tue Feb 19, 2008 9:22 am Post subject:

in general it is always good to upload your IR and RM files to the diagnostic areas and post links when you are asking for help. It's very difficult to guess as to what is going on without looking into what you have done
_________________
this JP1 stuff is a sickness!

vickyg2003 · Posted: Tue Feb 19, 2008 1:28 pm Post subject:

We need to see the files to figure out what is going on. I have a couple of guesses, but if I had the upgrade, and the IR file I could see if my guesses are correct or not.

e34m5 · Joined: 14 Oct 2003 Posts: 675 Location: Atlanta

Here it is. Non extended.

1067 file
_________________
Paul

vickyg2003 · Posted: Tue Feb 19, 2008 9:32 pm Post subject:

Paul, I think its odd that 0,4,5,6 all have the same hex. Do you have the RM file for this? I'd like to make sure the output matches the settings you are choosing in RM.

kupakai · Joined: 29 Sep 2006 Posts: 283 Location: New York

I've tried uploading to my Comcast 1067A and then used CaptureIR to verify the ir output. It seems to output exactly what it is supposed to. See screen capture:

What kind of problem are you having?

e34m5 · Joined: 14 Oct 2003 Posts: 675 Location: Atlanta

I don't use RM, only KM.

The problem is that the receiver does not respond to any commands. I tried this upgrade on a 8910, 15-2216 and Cinema7 and it worked fine.

So I am at a loss at this time to understand why the 1067 doesn't like it.
_________________
Paul

Nils_Ekberg · Posted: Wed Feb 20, 2008 8:01 am Post subject:

I don't see support for the 1067A in KM (I could be blind) so that may be the problem.

Post the KM file that you created and also the one that works on the other remotes so we can try to convert it for you in RM.
_________________
Nils
Files Section
Diagnosis File Section

vickyg2003 · Posted: Wed Feb 20, 2008 9:26 am Post subject:

I haven't seen 1067a support in KM either. I really wish the remote was supported by km, because I am familiar with the way KM works. I think trying to use an upgrade for another remote might be the cause of your problems.