Page 1 of 1
PCMCIA parrallel cards and JP1
Posted: Thu Feb 07, 2008 3:55 pm
by Ube_Astard
Does anyone know if the JP1 works ok with PCMICA cards?
Posted: Thu Feb 07, 2008 5:02 pm
by jherrick
I would expect (have not tried) that it would work only with the PCMCIA cards that actually emulate a parallel port. Most of the ones you find for cheap are fine for printers, but they are not actual emulators.
I researched this once, and about the cheapest I could find that looked like it would work was about $80.00. When you figure you can get a cheap older laptop on fleabay for less than that after shipping, I couldn't justify it.
Jim
Re: PCMCIA parrallel cards and JP1
Posted: Mon May 31, 2010 12:36 am
by javier
Ube_Astard wrote:Does anyone know if the JP1 works ok with PCMICA cards?
I have bought a $17 PCMCIA Parallel card and it works with my URC-8910 JP1 remote.
Because there are a lot of cards with different chips, look for a card with the MCS9805 chip inside.
This is the link for the card that I have bought:
http://cgi.ebay.com/110533099643
When installed, go to device manager in your PC and look for memory I/O resources of your new LPT device. I had to change the address 378 on IR.EXE associated to LPT1 for the new FFE8 of the new PCMCIA card.
If thist is not enough to get the card working, try to change the port configuration (interrrupt, Plug&Play legacy) on the Port Configuration tab of the card properties in device manager.
Good luck.