keymaster 9.12
RC5/6 Combo protocol
setup code =054
For RC5 functions, set 'byte2' = 0<space><RC5dev>. (RC5 device 0-31)"
where do i find rc5dev number???
what is correct entry??0 ??
rc5/6 combo function entries
Moderator: Moderators
rc5/6 combo function entries
uei remotes:
2-urc-8810,rs 1994,urc-6800,parrarel programing cable
sat-sony srv2000,direct hr10-250,dish 301,300,510,508,voom 550,hughes hird e-8,Samsung SIR-TS360
tv-ge
reciever-pioneer
ota-usdtv
dvd-pioneer dv503
2-urc-8810,rs 1994,urc-6800,parrarel programing cable
sat-sony srv2000,direct hr10-250,dish 301,300,510,508,voom 550,hughes hird e-8,Samsung SIR-TS360
tv-ge
reciever-pioneer
ota-usdtv
dvd-pioneer dv503
Re: rc5/6 combo function entries
I assume the above post is for the same device as your post atglikness wrote:where do i find rc5dev number???
https://www.hifi-remote.com/forums/viewt ... 5784#p65784
If I understood you correctly in that other post, you have a partially working RC5 upgrade that you are trying to convert to mixed RC5/RC6.
In the setup sheet of the partially working RC5 upgrade, one or more (up to three) RC5 device numbers are listed. If there is more than one, then each function on the function sheet has a value to distinguish which of them it uses. (In RM it is very clear. I haven't looked recently at how KM does that. I think KM still has just on index on the functions sheet into the values on the setup sheet. So a 2 on the functions sheet wouldn't mean device 2, it would mean the device in position 2 on the setup sheet. See the protocol help in KM.).
For any function that worked in the RC5 upgrade, the RC5 device number you want in the combo upgrade is the same one that worked in the RC5 upgrade.