JP1 Remotes

Has anybody tried to convert a Dish Network remote to a JP1 remote?

My father has finally figured out to use a Dish Network remote with my 622 via TV1 and TV2. But his Dish remote TV2 does not have a code for his TV (tried power scan too).

This link has info on the EEPROM chip used in a Dish remote
http://www.atmel.com/dyn/resources/prod ... oc0180.pdf. I don't have the knoweldge to do anything with this info! Anyone here willing to accept the task?

Many Thanks in advance

Duane

[/img]

doubtful

instead you can load up the Dish network upgrades into pretty much any JP1 remtote. The URC-6131 (modified by Rob) is good choice for the PVR. however, you can't get anything that will replace the UHF remote for TV2, I've tried numerous times to make a JP1 remote work but have not yet been successful.


-bill
\

Yes, the UHF part is my biggest problem!
I have already upgraded my RS 15-1994 remote with my home made cable. To do the PVR functions for the 921 I had, and now my 622 (on address 2). Also added DVD recorder funtions to AUX 1 device button.

Duane

This looks like where Dish uploads codes to the remote.

[/img]

That looks like where the slide switch to go from device to device goes.

On second thought this is where the UHF A to UHF B switch goes, on remotes that have the switch.

UHF Pro to UHF ?

Duane

Its a standard i2c EEPROM, which you could read with the JP1 interface and IR software. You are on your own though, figuring the data read out. I doubt you'd find much with that small an eeprom.