JP1 Remotes

[jorge garcia]

Hi, i have the URC-8810 i bought it a couple of years ago, it works great, and does connect to the parallel interface.

Ive done an upgrade for a coolsat 5000, which worked fine also.
But when i tried to LEARN KEYS from a Sony RDR-GX330 remote i noticed that it did not learn them.

i tried learning kesy from other 2 remotes ( tv and dvd), with no luck.

i also tried the MFR RESET , (setup, 2 flashes then 980, and setup 2 flashes and 981).

Any comments on what can be wrong?
i also read the sticky about the correct way to learn keys.

Help me out here!!

[whompus]

Your not reseting correctly. This is from the remote reset sticky in general section.

3) For the current LCD remotes (eg, URC-8910, etc):

- Press and hold SETUP until screen reads "CODE SET"
- Press RECORD
- Follow the prompts

[jorge garcia]

THanks whompus,

the thing is im not using an LCD remote, the URC-8810 is a non LCD remote.
i did read that sticky from the beginning, but i used this one instead:

1) For most non-LCD remotes:

- Press and hold SETUP (might be labelled SET, MAGIC or P), 2 flashes
- Type 981, 4 flashes

I also did the

- Press and hold SETUP (might be labelled SET, MAGIC or P), 2 flashes
- Type 980, 4 flashes


Doing this, it erases all my upgrades, and protocols, key moves, etc. but still no luck on LEARNING keys.

Any ideas?

[whompus]

My bad.. I misread as being an 8910.

It may be internally. If so I am not sure what if anything can be replaced to help.