JP1 connector on URC6800 VCR Pro 8

geraud · Post by **geraud** » Sun Sep 21, 2003 2:30 am

Hi

I would like to know how to make a JP1 cable with my URC6800, because my JP1 connector inside the remote has only 3 holes (number 1 on the left).
Thanks for your help.

(excuse me for my english language

)) )

Nico

Post by **The Robman** » Sun Sep 21, 2003 12:00 pm

Hi Nico,
Does your remote look like this...

If so, this remote was created before UEI started using EEPROMs, so there's not much chance that you can use JP1 with it.

But hey, your remote could be different, so you could try opening it up and seeing if there's an EEPROM chip on the circuit board somewhere.

Rob
http://www.hifi-remote.com

geraud · Post by **geraud** » Mon Sep 22, 2003 1:01 pm

Hi

My one is this :

But I'll try to open it and look to see if there's an eeprom inside...

Thanks

Nico

Post by **The Robman** » Mon Sep 22, 2003 5:23 pm

In that case, I imagine you can update it with JP1. Does it have a 6-pin connector in the battery compartment. This remote looks almost identical to the Maestro II which does have a 6-pin connector and does have JP1 support.

JP1 Remotes

JP1 connector on URC6800 VCR Pro 8

JP1 connector on URC6800 VCR Pro 8

Re old 6800