| View previous topic :: View next topic |
| Author |
Message |
Greg Williams
Joined: 26 Oct 2003
Posts: 8
Location: Mid Georgia
|
 Posted: Sun Nov 16, 2003 9:03 am Post subject: Commenting in IR.exe |
 |
|
Somewhere I saw a post (and cannot find it now) where there was a way to modify the RDF file so a description could be put in for the device protocol code so in keymoves and general you might see "Sony TiVo" vs. 2001.
Am I making this up??? I have searched on the JPI and yahoo forums to no avail...
Thanks ahead...
greg |
|
| Back to top |
|
 |
Mark Pierson
Expert
Joined: 03 Aug 2003
Posts: 3017
Location: Connecticut, USA
|
| Posted: Sun Nov 16, 2003 9:19 am Post subject: |
|
|
It's been discussed as something that would be nice to have, but AFAIK it can't currently be done.
_________________
Mark |
|
| Back to top |
|
|
sfhub
Joined: 12 Oct 2003
Posts: 287
|
| Posted: Sun Nov 16, 2003 10:14 am Post subject: |
|
|
Under the "[DeviceButtons]" section of the appropriate RDF file, I usually
change the db-0x to match the special protocols that are bound to them
like db-dsm, db-ldkp, etc., so I can remember them easier than
misc/1103 and misc/1106.
In my experience, in the same section, you can rename TV to SonyTV
and IR would display SonyTV in the UI. I don't know if that is answering
what you are asking. |
|
| Back to top |
|
|
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
File Section
Wiki
