JP1 Remotes

Hello all,
I have successfully downloaded and uploading using IR to my 9910 remote about 4 times. The last time I tried to upload, the remote's LCD display read MEM FAULT. I was like oh sh**. I then tried to reset the remote to factory defaults using the instructions in the manual. The LCD reads BAD E2. What does this mean? Has anybody else had this problem.

I am using a homemade JP1 parallel cable that has worked fine the first 4 downloads and uploads.

-Kevin (JP1 user in training)

here are two threads probably useful:

https://www.hifi-remote.com/forums/viewt ... =mem+fault

https://www.hifi-remote.com/forums/viewt ... =mem+fault

The little 'search' button at the top is your good friend

Thanks for the links, but I did see those threads before I posted. After reading those threads, I thought I would post a new thread because I have had successful uploads and downloads. I did not get that impression from the other threads.

Thanks for your quick response.

The bottom line is this:

If you do an OPS RESET, as described in the manual, the problems will persist.

But, if you do an MFR RESET, as described here, the problems should go away.

Thanks for the replies. I just kept downloading and uploading to the remote and now everything seems to be working just fine. I think I will do the manufacturer reset just to be on the safe side.