JP1 Remotes

[ToddF]

I have created an upgrade for the Philips 30PW862H widescreen HDTV and uploaded it into the yahoo files area. Enjoy...
Todd F.

[Alric]

Hi Todd,

I am having problems using the upgrade; most likey due to my inexperience with JP1.

My problem is that I can not produce a valid protocol ID within keymap master. I enter the parameters as in the upgrade file:

Devices:,RC-5,0,100,3

But I don't know how to enter these:

Manual:,,0 = 1-byte,LSB-COMP,86,NO

And this is how this part looks in KM;

Protocol ID: ## ##
Fixed Data: FF D9 3F
Manual Settings
Enter PID: RC-5
2nd Cmd Byte: None
Signal Style: LSB-COMP
Bits/Dev: 3
Bits/Cmd: 8

Any thoughts would be greatly appreciated. Thanks for the file!

[Mark Pierson]

[Alric]

Something may be wrong with my set up because after loading the file and selecting the remote the parameters are not filled in automatically.

A "code" is not produced and I get an error after I load the file and specify the remote:

Filename: Philips_30PW862H_widescreen_HDTV-tf_ver2.txt
*** Unsupported or unrecognized Protocol ***
Enter Device Codes and/or Raw Fixed Data (hex). Enter the Protocol ID and set the options in the Manual Settings table. Use the Notes section to enter any 3rd-Party Protocol Code.

On the protocol ID section I get:

Invalid Protocol ID

Upgrade Protocol 0 = ## ## (S3C8+) (KM v8.31)
Code cannot be calculated...
End


This happens in two different PCs.

Cheers,

[Mark Pierson]

[Alric]

Thanks Mark for taking a moment to look at this.

This is where I may be doing something wrong. It is saved to my HD as a .txt file. I just save it straight from the link to my desktop.

I am using an 8910 and load the file using the load button on the spreadsheet.

Thanks!

[Mark Pierson]

[Alric]

Got it. Its a browser difference! If I save the file from IE it works fine. Initially, I was using Firefox in both computers.

On further inspection there are extra underscores in the Firefox saved files.

Thanks!